[ Pobierz całość w formacie PDF ]
BO-1
BODY
Page
GENERAL INFORMATION
BO-2
HOOD
BO-5
FRONT DOOR
BO-7
BACK DOOR
Right Back Door
BO-15
Left Back Door
BO-20
MOULDING
Windshield Moulding
BO-23
Body Outside Moulding
BO-24
Back Door Moulding
BO-25
Wheel Opening Extension
BO-26
WINDSHIELD
BO-28
QUARTER WINDOW GLASS
BO-32
BACK DOOR GLASS
BO-37
BACK WINDOW GLASS
BO-38
MOON ROOF
BO-43
INSTRUMENT PANEL
BO-50
TARPAULIN
BO-57
TARPAULIN SPARS
BO-62
FRP TOP
BO-63
ROLL BAR
BO-65
SEAT
BO-66
SEAT BELTS
BO-71
FUEL TANK AND LINE
BO-74
FRAME DIMENSIONS
BO-76
BO-2
BODY -
General Information
GENERAL INFORMATION
HANDLING PRECAUTIONS
If there is a possibility that the body and/ or parts maybe
damaged, first remove the danger before performing re-
pair operations
.
Example
:
1 . Apply protection tape to the body adjacent to the
body parts when removing and installing .
2.
When prying off the body parts with a screwdriver
or scraper etc ., be sure to apply protection tape t
the tip or blade to prevent damage to the paint fil
or body parts.
ANTI-RUST TREATMENT
If anti-rust agents are damaged while repairing oth
parts, be sure to repair the anti-rust agent
.
Example :
1 . If body sealant, paint film or undercoat are damag
by peeling, cracks, etc
., be sure to repair each w'
an anti-rust agent.
2 .
If a hinge or exterior body panel is loosened or
moved, be sure apply rust inhibitor after repairs
.
BODY - General Information
BO-3
CLIPS
The removal and installation methods of typical clips
used in body parts are shown in the table below .
HINT: If the clip is damaged during the operation, al-
ways replace it with a new clip .
Removal/Installation
B04116
B04117
t
t
B04119
B041 18
804120
804121
Ar
BO-4
BODY
-
General Information
CLIPS (Cont'd)
Shape (Example)
Removal/Installation
Removal
Installation
FRA
III 1i
r
B04122
B04123
Removal
Installation
B04124
B041
HOOD
ADJUSTMENT OF HOOD
HINT : Since the centering bolt is used as the hood hinge
set bolt, the hood cannot be adjusted with it on
. Substi-
tute the bolt with the washer for the centering bolt
.
1 . ADJUST HOOD IN FORWARD/REARWARD AND
LEFT/RIGHT DIRECTIONS
Adjust the hood by loosening the hood side hinge bolts .
2 . ADJUST REAR EDGE OF HOOD IN VERTICAL
DIRECTION
(a) Remove two nuts and the wiper arms .
(b) Remove two clips, six screws and the cowl louver
.
(c) Adjust the hood by increasing or decreasing the
number of the shims.
3.
ADJUST FRONT EDGE OF HOOD IN VERTICAL
DIRECTIONS
(a) Loosen the lock nut .
(b) Adjust the hood by turning the cushions
.
[ Pobierz całość w formacie PDF ]